Agilent 8960 - Wireless Communications Test Set

• Supports GSM/GPRS/EGPRS/E-EDGE, W-CDMA/HSPA/HSPA+, cdma2000®/1xEV-DO/eHRPD, TD-SCDMA/TD-HSDPA/TD-HSUPA, IS-95, TIA/EIA-136 and AMPS wireless device testing
• Software upgradeable for quick access to new functionality
• Integrate with WTM software for quick automation of RF and parametric tests
• Remotely controllable through GPIB interface
• 292 to 2700 MHz frequency range includes all commercial 3GPP and 3GPP2 frequency bands
• -110 to -13 dBm output level range with modulation
• VSWR <1.2:1 400 to 2000 MHz
• < ±1.0 dB channel power measurement accuracy



Agilent E8285A - CDMA Mobile Station Test Set

• CDMA cellular, CDMA PCS, and analog cellular coverage in one-button call setup
• Built in AWGN source for calibrated E b /N t receiver testing
• Flexible base station emulation
• Extremely fast CDMA and analog testing
• High accuracy and repeatability
• Gated power and open loop response graphical measurements
• Simultaneous receiver and transmitter measurements
• Electronic attenuator and RF front end
• CDMA and analog authentication testing
• CDMA SMS testing



Agilent PCM 8922 - GSM Mobile Station Test Set

• GSM RF Test Set designed for high volume manufacturing
• Can be used in conjunction with an Agilent 83220A/E, the frequency range is extended to Cover the DCS1800 and PCS1900 bands
• One button call set-up from power on
• GSM Phase II compatible (including fast burst BER measurements and Enhanced Full-rate Speech)
• High Speed Circuit Switched Data (HSCSD)
• E-GSM and Dual-band assignment capability
• Electronic attenuators for increased reliability
• Tool kit of instruments including spectrum and audio analyzers
• Full control over GPIB
• Full automatic testing of a GSM mobile phone
• RF Generator, RF analyzer, and Spectrum Analyzer range of 10 MHz to 100 MHz



ANRITSU MS8604A - Digital Mobile Radio Transmitter Tester

• Major transmitter functions evaluated by a single system
• Compatible with NADC, PDC, PHS, Digital MCA, GSM, DCS1800 (PCN), CT2, DECT, WCPE, PACS, RCR STD-39 TETRA systems, and GMSK and pi/4 DQPSK universal measurement
• High-speed measurement (under 1 second for modulation-accuracy measurements)
• Input up to 10W (internal 20dB attenuator and power meter for high power levels)
• Frequency range 100Hz to 8.5GHz
• Maximum input level +40 dBm (10 W)



ANRITSU MS8609A - Digital Mobile Radio Transmitter Tester

• Resolution bandwidths up to 20 MHz
• all Vector Signal Analysis (VSA) functions through high-speed DSP
power measurements of ±0.4 dB by using an amorphous power sensor
• Measurement software options: W-CDMA, GSM/EDGE, HSDPA, WLAN/802.11, CDMA, 1xEVDO
• Input signals RF or I/Q inputs
• For I/Q signals balanced or unbalanced input
• GPIB, RS-232C, 10BASE-TEthernet interfaces for remote measurement
• TFT color LCD
• 9 kHz-13.2 GHz, input power up to +20 dBm



ANRITSU MT8801B - Radio Communication Analyzer

• RF Communication Tester Type: Base Station,Mobile
• Communication Standard: DCS1800, DECT, GSM900, PCS1900, PDC, PHS
• Signal Generator Frequency 300 kHz to 3 GHz
• Signal Generator Modulation FM
• Signal Generator Resolution 1 Hz
• Power Meter Minimum Frequency 300 kHz
• Power Meter Maximum Frequency 3 GHz



ANRITSU MT8820A - Radio Communication Analyzer

• Frequency range 30 MHz to 2.7GHz
• Advanced DSP and parallel measurement technologies for fast test time
• 3GPP call processing including Registration; Origination, and Termination
• 2 Transmitter measurements items including Modulation analysis; Adjacent channel power ratio and Peak code domain error according to 3GPP TS34.121
• Bit Error rate (BER) and Block Error rate (BLER) receiver measurements using 3GPP loopback method
• "One-touch" Batch measurement operating mode with Pass/Fail evaluation
• Multi-system W-CDMA / GSM capability
• 1xEV-DO support including external packet data communications measurement capability and IP data communications mode
• EDGE/EGPRS measurement software supporting MCS1-MCS4 (GMSK modulation) and MCS5-MCS9 (8PSK modulation) coding
• HSDPA call processing and RF transmission/reception measurements for mobile terminals with UE category 1 to 6, 11, and 12
• Parallel phone measurement to increase measurement speed, reduce production costs, and save manufacturing space



HP E4406A - VSA Series Transmitter Tester

• Vector signal analyzer (VSA)
• Full-featured transmitter tester 7 MHz-4.0 Ghz;
• For wireless base station and mobile transmitters and their components
• Provides the best combination of speed and accuracy for a wide range of digital modulation analysis capability
• Multiformat capability (W-CDMA, cdma2000, 1xEV-DO, cdmaOne, EDGE, GSM, NADC, and PDC).



Rohde & Schwarz CMD 80 - Digital Radio Communication Tester

• Fast measurement speed
• High measurement accuracy and repeatability
• Triple mode (CDMA, TDMA, Analog) dual band (cellular, PCS) in one box
• Remote control via IEEE488/IEC625 bus)
• Autotest - complete mobile testing at a keystroke
• Remote control via GPIB or RS232
• Suitable for production, development and service
• Very fast remote control operation
• Voice lookback and comprehensive testing of mobiles
• Powerful signaling capabilties
• Simple interactive operation
• Compact and lightweight
• Service mode for exact fault location



Rohde & Schwarz CMS 50 - Radiocommunication Service Monitor

• Frequency Range 0.4 MHz to 1 GHz
• Frequency resolution 50 Hz
• Level - FM: M, CW ≤ -134 to 0 dBm
• AM -134 to -3 dBm
• Modulation Frequency range 2 MHz to 500 MHz
• AM Modulation Depth 0% to 99%
• Modulation Frequency Range 15 Hz to 10 kHz. f < 8 MHz
• FM Deviation 50 Hz to 50 kHz
• M Deviation (internal) 0 to 10 rad.
• Modulation Modes Internal (single tone/two-tone), external, internal + external
• AF Voltmeter Frequency Range 50 Hz to 20 kHz
• Measurement Range 0.1 mV to 30 V
• RF Power Meter Frequency Range 2 MHz to 1 GHz, Measurement Range 5 mW to 50 W
• RF Frequency Counter Frequency Range 0.5 MHz to 1 GHz
• Frequency Deviation Meter Frequency Deviation Meter +PK, -PK, ±PK/2, PK HOLD, RMS, RMS²/²
• Phase Deviation Meter Operating Modes +PK, -PK, ±PK/2, RMS, RMS²/²
• AM Depth Meter Operating Modes +PK, -PK, ±PK/2, RMS, RMS²/²
• RF Spectrum Monitor Reference Level +47 to -47 dBm. (Input 1)
• Display Dynamic Range >60 dB (≥7 dBm reference level at input 1)
• Span 0 (zero span) to 50 MHz
• Tracking Generator (Option 04 or 24 required) Frequency Range 400 KHz to 1 GHz, Reference Level -27 to -67 dBm
• Transmitter and Receiver Measurements: Distortion Meter 100 Hz to 3 kHz, SINAD Meter 1 kHz ± 10 Hz
• AF Frequency Counter Operating Modes: Demodulation, AF, beat (frequency offset), external
• Oscilloscope Bandwidth DC to 20 kHz



Rohde & Schwarz CMS 57 - Radiocommunication Service Monitors

• RF synthesizer from 0.4 to 1000 MHz, resolution 10 Hz, with AM, FM, φM and multitone modulation capabilities
• Two independent modulation generators, from 20 Hz to 30 kHz each, resolution 0.1 Hz
• Selective-call encoder to all standards (also user-programmable)
• CDCSS coder
• DTMF coder
• 10 MHz reference frequency input/output
• VOR/ILS signal generator
• RF frequency counter, RF frequency-offset counter
• Power meter from 5 mW to 100 W
• Selective RF power meter down to -100 dBm
• RF spectrum monitor with wide dynamic range and filters which also allow modulation analysis (AM, FM, SSB)
• Tracking generator in frequency range from 400 kHz to 1000 MHz
• Adjacent-channel power meter with standard ETSI filters
• Modulation meter for AM, FM and jM; weighting: +PK, -PK, PK HOLD, PK/2, RMS, RMS2
• Duplex modulation meter for duplex spacings of any size
• AF voltmeter with peak and true RMS weighting
• SINAD meter with variable test frequency
• S/N meter
• Distortion meter with variable test frequency
• AF frequency counter with period and gate-time counting
• Selective-call decoder for all standards (also user-programmable)
• DTMF decoder
• CDCSS decoder
• Oscilloscope
• DC ammeter/voltmeter
• Transient recorder for analysis of power and frequency transients
• Cable fault test
• CCITT or C-message filters for weighting to relevant standards
• Continuously tunable bandpass filter from 50 Hz to 5 kHz with high skirt selectivity for selective modulation and AF measurement
• Continuously tunable notch filter from 100 Hz to 5 kHz for signal suppression
• Highpass and lowpass filters for band limiting and measurement of subaudio tones
• Second RF input with high sensitivity for off-air measurements, can be used independently for module testing
• Built-in 600 Ω AF transformers for modulation generator and AF voltmeter
• Connector for battery (11 V to 32 V)
• 13 dBm RF output for off-air measurements
• Memory for storing complete instrument setups



Rohde & Schwarz CMU 200 - Radio Communication Tester

• 3GPP WCDMA (FDD)
• 3GPP HSPA
• GSM/GPRS/EDGE
• GSM-R
• AMPS and IS-136
• CDMA2000® 1xRTT
• CDMA2000® 1xEV-DO
• IEEE 802.15.1 Bluetooth



Tektronix WCA 380 - Wireless Communication Analyzers

• DC to 8 GHz Coverage - Seamless Capture up to 30 MHz BW
• 65 dB ACLR Measurement (3GPP)
• Code Domain Power and Complementary Cumulative Distribution Function (CCDF) for IS-95, 3GPP (3GPP • Release 99) Signals
• Analyzes in Frequency, Time and Modulation Domains
• Seamless Acquisition for Capture of Short Duration or Intermittent Events
• Frequency Event Trigger for Acquisition of Burst or Infrequently Occurring Signals
• Post Capture 1000:1 Zoom Allows Analysis of Individual Signals After Wideband Capture
• Support Demodulation - GFSK, BPSK, QPSK, DQPSK, 8PSK, OQPSK, 16QAM, 64QAM, 256QAM, GMSK
• CCDF for Multi-carrier and 3GPP Signal



WAVETEK 3600D - Cellular Test System

• Cellular Test System for AMPS/NAMPS
• Communication Standard: AMPS, CDMA, NAMPS, TDMA
• Centronics, GPIB, RS232
• Data Storage CF,HDD