Network Analyzers

Agilent E5071C - ENA Series Network Analyzer

Agilent E5071c
  • Wide dynamic range: > 123 dB dynamic range at test port (typical)
  • Fast measurement speed 41 ms @ full 2-port cal, 1601 points
  • Low trace noise 0.004 dB rms @ 70 kHz IFBW
  • Integrated S-parameter test set
  • Port options 2-port and 4-port
  • Balanced measurements (4-port option)
  • Frequency options 300 kHz - 20 GHz (with bias tees)

Agilent E8364C - PNA Microwave Network Analyzer

Agilent E8364c
  • 10 MHz to 50 GHz
  • 104 dB of dynamic range and <0.006 dB trace noise
  • <26 usec/point measurement speed, 32 channels, 20,001 points
  • TRM/LRM calibration for the most accurate on-wafer, in-fixture, waveguide, and antenna measurements
  • Mixer conversion loss, return loss, isolation, and absolute group delay
  • Amplifier gain compression, harmonic, IMD, and pulsed-RF

Agilent HP 8517B - S-Parameter Test Set

Agilent Hp8517B
  • Frequency Range 0.045 to 50 GHz
  • Test Ports (port 1 or 2)
  • Nominal Operating Power Level: +2 to -29 dBm, Opt 007: +5 to -16 dBm
  • Connector Type: 2.4 mm, male
  • Impedance, DC Bias: 50 ohm nominal, 500 mA, 40 Vdc maximum
  • Attenuation Range (incident signal): 0 to 60 dB, in 10 dB steps

Keysight N5230C 20GHz 4Port PNA-L Network Analyzer

Keysight N5230
  • 4-port configurable test set
  • 300 kHz to 20 GHz
  • 2- or 4- ports with two built-in sources
  • 110 dB system and 122 dB receiver dynamic range, 32,001 points,  32 channels
  • < .006 dB rms
  • Measurement speed: 4 to 9 µs per point
  • Gain, gain flatness, reverse isolation, and return loss
  • Simple, fast, and accurate AM-AM and AM-PM compression measurements  with the Gain Compression Application with 38 dB power sweep range at  20 GHz, +13 dBm output power
  • Test harmonics accurately with < 60 dBc source harmonics, no need for external filters